Kenworth T800 vs T880: What Kenworth and NHTSA Records Actually Say

T800 vs T880: Kenworth pitches the wide-hood T800W for heavy haul; the T880 lists up to 605 hp and bolt-on fenders. Several NHTSA recalls name both.

Updated: 2026-10-27

Short answer: Kenworth's current T800 page covers the wide-hood T800W, which it pitches for heavy haul. Its T880 page lists engine ratings up to 605 hp / 2050 lb-ft on the T880S Performance Hood and bolt-on fenders that can each be replaced in less than two hours. Neither page gives used-truck reliability data, so the most useful check is recall history: several NHTSA recalls name both trucks, including an X15 fuel line, an ISX 15L fuel pump drive gear and a fuel rail sealing washer. Look up the VIN for open recalls before you buy.

What Kenworth says about the T800

Kenworth's current T800 page describes the wide-hood T800W, not every T800 ever built. The claims are marketing, but they are the maker's own words.

The T800W will exceed your heavy haul needs.

The page also says the following about the truck.

The T800W possesses the strength and versatility to tackle whatever task your business can throw at it.

It gives no used-truck guidance, no service intervals and no failure data, so it cannot rank a T800 against a T880 on reliability.

What Kenworth says about the T880

Kenworth describes the T880 this way on its own page.

The T880 is one of the most proven and versatile work trucks ever conceived.
  • Kenworth lists engine ratings available up to 605 hp / 2050 LB-FT for the T880S Performance Hood.
  • For the bolt-on fender design, Kenworth states that each fender can be replaced in less than two hours.

These are maker claims about the current truck. They do not describe the condition of any particular used unit.

Recalls that name these trucks

NHTSA recall records show defects that a manufacturer reported to the government. They tell you what was found, not how often it happened. Several recalls name both trucks, and the engines involved are worth knowing before you buy.

  • Cummins X15 fuel line. The recall covers Kenworth T800 and T880 trucks with ISX15 or X15 engines. NHTSA's summary says the fuel line may burst if the fuel pump cooling circuit screen becomes restricted.
  • Cummins ISX 15L fuel pump. NHTSA's summary describes a fuel pump drive gear that could slip on its drive shaft and cause an engine stall.
  • Fuel rail leak. The recall scope lists both the T800 and the T880, and the defect is a sealing washer that may not seat correctly.
  • 2008 T800 with C15 engines. The recall says the aftertreatment regeneration device may develop a hole during a regeneration of the diesel particulate filter.
  • DPF bracket. An older recall that includes the T800 says the bracket could allow the filter to separate from the chassis.

Ask any seller for proof that recall work on the specific truck was completed.

Federal warranty rule for engine emission parts

Federal rules require engine makers to warrant emission control parts. The rule says the maker must warrant the engine to the ultimate purchaser and each subsequent purchaser, which includes a second owner. Minimum warranty periods are set in miles, hours or years, so the coverage left on a used truck depends on its in-service date and mileage. Confirm that with the engine maker using the truck's serial number.

What we cannot tell you

No official source gives used T800 or T880 prices, repair costs or failure rates. If a page gives you those numbers without naming where they came from, treat them as unverified.

How this guide changed

Earlier versions of this guide cited dealer asking prices, one dealer's fleet pricing, repair-shop turbo costs and forum failure stories. We removed them because no official source states them. This rewrite uses only Kenworth's own pages, government recall records and the federal engine warranty rule.

Sources

Every quotation above was fetched from the document linked here and matched word for word on 2026-10-27.